2017年5月7日 · Among its functions are those normally handled by a conventional Park/Neutral switch: it prevents the engine from starting in any gear other than Park or Neutral. and closes the circuit for the back-up lights when the shift lever is moved to Reverse. The TR sensor also contains the sensing circuit for Neutral in 4X4 Low range on 4WD models.It ...

Ok this circuit is very simple. It is fuse 12 a 10amp then to the back up light switch on the transmission and to the lights thats it. So I would check the back up light switch. So with multi meter you can check the yellow wire to the switch for power when in reverse the green wire should then send power to the lights. Let me know what you find.

The auto transmission does not have a reverse lamp switch, only the manual. Take a look at the info attached for the back up lamp switch on manual transmissions for the location and wiring info. If it is an auto transmission then you have a range sensor that is …

John, on a automatic it is your neutral saftey switch, follow your gear selector linkage to your tranny, Where your gear selector goes into the tranny is where your switch is, it should have two bolts that hold it in. On a manuel, I believe it is on top of the tranny, closer to drivers side about half way back. Hope this helps.

2020年1月28日 · I am installing a backup camera and am trying to locate a place under the dash to tie the reverse sensor wire to the wire feeding the backup lights. I could route the wire under the vehicle to the backup lights but would prefer to do it under the dash if possible. I would like a specific location to do that.

2023年7月22日 · Most of the new switches include a plastic alignment tool to set the location, use it and tighten the switch down. If there is no tool, plug the switch in, turn on the key and put the shifter into reverse. Now move the switch until the reverse lights come on. Note the location of the bolt, now move it the same direction until they go off.

Check out 10-amp fuse labeled "GAUGE" in instrument panel junction box. If fuse is OK, suspect faulty back-up light switch (located on the transaxle). Here are diagrams to help you see how to replace the reverse light switch or gear range sensor …

The tiny backup light switch is on the driver's side rear of the transmission, but it doesn't turn on the lights directly like it did for the last 40 years. It grounds a 5 volt signal, and that tells the Integrated Power Module to turn on a computer switching circuit to …

2018年9月3日 · Im having issues with the back up light switch. It needs replacing. Apparently I can not find the exact location. The engine is 2.0 liter 147 hp manual transmission. If anyone can share exact location or even photos that would be great! Thanks in advance!

Backup light switch. MIKE MCCULLOUGH MEMBER; 1994 DODGE RAM ... Related Reverse Light Switch Location ...