2014年2月12日 · Circle saw set works. Started by chopperdr47, February 12, 2014, 10:58:59 AM. Previous topic - Next topic ...

2011年7月11日 · shelby,what you need is a decent used saw belsaws will handle a little bigger saw like 42" or44"some guys go bigger but its a little iffy due to the diameter of the arbor.Scotchbrite pads on an angle grinder do a good job.Be sure you have the bits and shanks in the saw when you clean it and be carefull you don't round edges. Frank C.

2015年5月4日 · When you run a circle mill for a farm show with members tractors you just open the throttle and saw with the speed you got . The best I can get out of the 80 HP steam tractor is about 525 . NO I am not going to re hammer the saw .

2017年11月28日 · This question is geared towards the Mobile Dimension saw users and also stationary circle mill guys too. I have a mobile dimension saw. It uses a #3 insert tooth for all blades. Its my belief that MD is the only MFGer left using this tooth. There is only ONE source for teeth in a #3 (simonds).

2023年11月28日 · Circle saw headrig problems. Started by Robert.schade, November 28, 2023, 05:27:44 PM. Previous topic - Next topic. 0 Members and 1 Guest are viewing this topic.

2015年8月5日 · Chris, I run a circle saw down in A us and also been on a Lucas 11 years. By the sound of it, with the maple not being flat on the carriage, as the blade has cut through it, the log has been pulled down onto the carriage and this has caused friction on your blade. If my blades get hot to touch, then asawdoctoring they go.

2023年3月25日 · A little light wire wheel work (my whisker machine) and then bouncing the power planer here and there off of the high spots for the circle saw look will produce a pretty good looking board. From this point, some colouration, light sanding, more colouration, etc. then sealing will yield the old time look a lot of people want.

2020年11月20日 · The price for one thing. Stand all's take more power. Stand all's handle the sawdust different from regular bits and help saw hard hardwood and frozen logs.

2024年4月3日 · Old circle saw fix up/ Identification . Started by ryan_ande, April 03, 2024, 06:15:33 PM. Previous topic - Next topic

2005年10月16日 · Saws with a number designation, 2 1/2, 3, 3 1/2, and 4 1/2, have single circle sockets. The shank and bit fit within the same circle in the saw. Letter designated saws, B, D, and F, have double circle sockets. This is a much stronger system than the single circle, and spreads the load over a greater area.